USING A SET OF HEM ROLLS:
This video gives instruction on the proper use of the Mittler Bros. Hem Step Roll Set. This easy, three-step process creates hem rolls approximately 1/4″ deep on steel or aluminum up to .040″ thick without marring pre-painted aluminum. Rolls are available in HEAT-TREATED STEEL or COMBO STEEL & NYLATRON.
PUNCHING JUST A HOLE WITH A SET OF PUNCH AND FLARES:
In this video you just drill a pilot hole for the draw bolt, then apply the tool and tighten the bolt for a smooth, flared or beaded hole in one easy step. Punch hole only by removing female flare ring and use punch and die. Easliy mounts in our Bench Presses.
You can call me at 636-745-7757 ext 116 for all of your metal forming equipment.
GreaserAlley 